How It Works

The Deluxe AttackWall features all the advantages of a Standard AttackWall with one added benefit; rear wall control.

lateral diffusing in the attackwall

Vertical Diffusion from the AttackWall

The AttackWall absorbs early reflections and lets others escape to become processed into time delayed backfill. Without an ambient tail to the ETC a reflection free recording studio would be exhausting to work in. The AttackWall is setup to vent treble in two ways. Some of the sound escapes over the top and under the bottom of the AttackWall. Other parts pass through the openings to the side and behind the engineer. Any sound that escapes the AttackWall reflects off the room walls back into the diffusing side of the AttackWall where it is again back splashed towards the wall. By this process a time delayed diffusive backfill of sound bleeds back through the opening in the Wall, over the top and under the bottom. The AttackWall creates an LEDE type mixing environment.

The mix has to be not only good but it has to hang together. To get "the mix" the engineer has to work in a clean and linear acoustic environment. The AttackWall provides just that and one thing more: Consistency. Inside the AttackWall, the sound is the same no matter where it's set up. That means when you finally do move, your whole studio moves with you. Your electronics and your acoustics. Take a step towards complete control in the mix.

Early Reflection Control

early reflections controlled by attackwall acoustics

The AttackWall wraps around the console and engineer so neatly that very little sound escapes outside of the Wall. Early reflections are controlled within the Walls' absorptive inner boundaries creating a reflection free zone right in the middle of the room, any room. 

The side sections of the AttackWall extend past the bolster of the console and engineer's head. This casts a huge acoustic shadow onto the wall, eliminating wall reflections and other lateral energy from getting to the mix position. In studios with wall mounted acoustics the wall reflections are usually controlled by absorbing wall panels, but here, sound can't get to the walls so sound panels aren't necessary. When lateral wall reflections are eliminated, excellent tonal reproduction and precise imaging is achieved.

A tight pattern of StudioTraps fits between the monitors and a loose pattern of StudioTraps is placed behind the engineer. These intercept and control the reflections off the front and rear walls. At this point, the engineer has created a reflective free zone around the mix position. The technique used here is acoustic shadow casting. Absorption takes palce very early, within a few feet of the speakers and long before the early reflections can ever reach the wall. The AttackWall has essentially removed the mix position from the room acoustic.